Monroe sits on the Skykomish, with the fairgrounds on the edge of town. River-bottom ground stays wet, and a yard built as if the water table were low will heave, puddle, or grow moss until someone deals with the water. After high water, the film on a low patio may be silt. It washes off once. If the water returns, the washing is not the repair.
Snohomish County · ZIP 98272 · 2020 population 19,608
Silt is not mildew
We clean what the last season left on the walks, the siding, and the patio on the dry side of the house. We do not power-wash a soaked floodplain into a polished surface. Mud on a soft lawn gets raked, not blasted into the grass.
Painted porches on older houses get a gentle setting. A lot of that paint is what is holding the wood together visually, and aggressively washing it shows every failure at once.
The ground in Monroe
We see two kinds of lots. In town, smaller yards with the usual compacted soil and a lawn that has to look fine for most of the year. Closer to the river and the low ground, soils that remember high water. Gravel and drains belong there. A finished bark bed in a spot that floods is mulch in the neighbor’s fence line by spring.
The fair is part of the calendar. People want yards cleaned up and hedges cut back before the traffic and the guests, and they want storm debris gone after the first big fall wind. Trees on these lots — including the old fruit trees — need pruning that opens them up, not a topping that makes them dangerous. Native plantings along the wet edges do the work a lawn cannot.
How we do the work
Most of what people call pressure washing here is organic film: the black and green on the north side, the walks, the fence. The fix is the right tip, the right distance, and often a wash that kills the growth so it does not return in a month. A zero-degree tip on a soft wood deck is how you get a furred, ruined deck.
We do not drive water up under lap siding or into a vent to prove the washer is strong. High pressure is for concrete that can take it. Wood, paint, and mortar joints get a softer approach.
What we look at first
- What the surface is
- Where the water will run
- Plants and outlets we need to protect
- Whether the black is mildew that needs a treatment, not just a blast
What will not come out
Rust, deep oil, and etching that is already in the concrete. We can fade some of it. We will not promise a new slab. Paint that is loose will leave with the dirt, and you will see the bare spots. We point those out first if we can.
Treatment
A wash that kills the algae and mildew, applied and rinsed, is why the surface stays clean longer than a blast. We use it where the film is biological. We do not soak your vegetable bed in it. Plants get rinsed.
Wood versus concrete
Concrete can take a stronger wash. Cedar decks, fences, and soft siding cannot. If we raise the grain, the surface holds more dirt afterward. We would rather leave it a shade less bright than furred.
More from this crew
- Pressure washing across Snohomish County
- Patio installation in Monroe
- Paver installation in Monroe
- Fence installation in Monroe
- Yard cleanup in Monroe
- Pressure washing in Sultan
- Pressure washing in Snohomish
- Pressure washing in Gold Bar
Sources for the climate and the water
- USDA plant hardiness map for choosing plants that can take a Snohomish County winter.
- EPA WaterSense on watering less once a lawn or a new planting is established.
- EPA Soak Up the Rain on keeping roof and yard water from becoming someone else’s problem.
